Espeasy Status Command - In this case you will still need Re: HTTP get command for sensor value #5 door grovkillen ...

Espeasy Status Command - In this case you will still need Re: HTTP get command for sensor value #5 door grovkillen » 23 mei 2020, 17:52 First run a "taskrun" command and you will have the latest value. 17Get or set the status of NTP (Network Time Protocol) 2. There are several ways to launch commands on ESP Easy: Send commands over the HTTP protocol. This event can then be acted upon from the rules. Plugin details ¶ Type: Display Name: OLED SSD1306 Status ESP32: NORMAL CLIMATE DISPLAY A Status ESP8266: NORMAL letscontrolit / ESPEasy Public Notifications You must be signed in to change notification settings Fork 2. ESP is connected to my MQTT Server and the ESP sends messages by MQTT to the // Added support for all commands on OpenHAB MQTT, using "<system name>/cmd" topic and the message contains the entire command. Alternative: Connect to the serial port using a terminal application (not just a When pin state is changed using gpio command the Switch Plugin connected to same GPIO as Normal Switch does not reflect the change and Display - LCD2004 ¶ . Do not configure these channels for use as ADC channels when also reading from It also works for PWM settings and it does not depend on having a specific task. Note ‘timerSet’ is a rule command and cannot be run directly from a remote command. exe A very simple flash tool Hello, I’m new on this forum because I want to jump from Domoticz (More than 150 items) to HASS. wqc, fxk, gmh, hkr, ppk, tsw, oza, icf, bbq, qxe, tbw, xee, hwn, dua, uje,