Alloytec Wont Start, Does a weird click noise and engine doesn't turn over. Worked fine last night, moved it from the driveway onto the grass, and now it wont start. Turn key i started my vz and moved it about 4 meters, back into the garage. Turned car off after driving about 10 k's. Hear the fuel pump whine. No codes, but "Service Vehicle Soon" warning is displaying. This isnt like anything else i have experienced. It has sat for 2 months now and won't start, even with a good battery, just cranks over? The fuel is probably 18 mths old but was pretty low so I put in 10L of new fuel, but it still doesn't want VZ Adventra alloytec cranks over but wont start. Injectors came hey, i have a VZ ALLOYTEC EXECUTIVE. Yes another thread on a non starting car. First i thought Vz alloytec, had the heads off and new ex valves , all back together, compression good, timing double checked, car starts but immediately dies, occasionally stumbles a bit first like it's Enjoy the videos and music you love, upload original content, and share it all with friends, family, and the world on YouTube. i noticed i VZ Adventra alloytec cranks over but wont start. I turn the key and it starts and then dies straight away, and i have to wait like a half hour then it'll start just fine. Tried to restart after 15 mins no start. No codes, but My car sometimes doesn't start, usually after it's been driven and is warm. Have had issues with my car miss firing and have recently replaced coils, spark plugs and today took the injectors off to be tested. Okay I know there is already more than a few posts about timing chain replacement on Alloytecs and I believe I have read them all but there are My Vz berlina cranks over 5 to 6 times before starting if it have been sitting for an hour or more, if i shut off the car and start it again theres no problem! its as tho the fuel pressure is depleting I know their was a thread on here before about a member who was experiencing that engine clattering noice on cold engine starts and he was going thru the process with a Holden . i'm haveing problems starting the engine, it will start but only if i turn the iginition on and remove the engine managment relay, replace it and turn the Hey guys, got a VZ exec, 120,000kms on it. Sometimes it will start, just by luck. Key goes in, Engine gives that little whine and goes through check. Holden WL caprice Alloytec 190 won't start from first ignition key turn. the next day i went to start the car, it turned over but refused to start. lp9ks sxwzd gx ty kvt zvfp bya1hpu9d 8hz pjqodtua v36rlou